Using Tmc; Updating The Announcement List; Station Selection - Becker TRAFFIC ASSIST PRO 7929 Operating Instructions Manual

Navigational mode

Using TMC

Once you have connected the TMC
antenna, your Traffic Assist Pro will
receive current traffic announcements
and dynamic route calculation will be
enabled (traffic jam diversion). You can
also view traffic announcements
directly.
To preset the TMC, See "The TMC
button" on page 55.
! Press the map on the map display.
6071
Press the TMC button.
!
All current traffic announcements are
displayed.
6071
58
Press the arrow buttons to the left and
right of the announcement number to
browse through the
announcements.
The road number (motorway, A-road or
district roads), section of road if
applicable, traffic direction and the type
of problem are displayed in each traffic
message.

Updating the announcement list

! To update traffic announcements,
press .
6070

Station selection

You can select a TMC station in three
traffic different ways: automatically or via the
station name or frequency. Press the
button at the top right of the screen to
switch between the three options.
Default setting is Automatic tuning.
Setting Meaning
Automatic tu- The automatic station
ning search is active. Select a
station using the arrow
buttons.
Stations preset via Auto-
Hold
matic tuning or Frequen-
cy input are tuned in un-
til you drive out of their
reception range.
Frequency in- If you know the station
put frequency, you can tune
into the station in this
mode using the arrow
buttons.