Activating/Deactivating Automatic Connection; Refreshing The Phonebook; Setting The Telephone Volume; Device Name - Becker TRAFFIC ASSIST 7977 Instructions For Use Manual

>>> TELEPHONE MODE*
Activating/deactivating automatic con-
nection
> EN
Here you can specify whether, after the
Traffic Assist is switched on, a connection
should automatically be established with
the last mobile phone connected.
> Press the
Automatic connection
in the telephone/Bluetooth settings to
activate or deactivate
connection.

Refreshing the phonebook

You can instruct your Traffic Assist to
transfer the phonebook data from the mo-
bile phone again. The phonebook is then
refreshed accordingly.
> Press the
Reload Phonebook
the telephone/Bluetooth settings.
82

Setting the telephone volume

You can set the volume of the telephone.
> Press the
Volume
phone/Bluetooth settings.
button
automatic
> Select the desired volume using the
and
> Confirm your settings by pressing the
button.
OK
WARNING
button in
The volume of the unit should be set so
that noises outside the vehicle can be
heard.
Note:
The volume can also be changed using
the volume control located on the side.
See "Volume control" on page 34..
*Applies only to the Bluetooth®-enabled Traffic Assist 7977

Device name

You can give your Traffic Assist a name.
button in the tele- This name will be displayed by other
Bluetooth devices.
Note:
The current name is shown in brackets
on the
> Press the
in the telephone/Bluetooth settings.
An input menu opens.
> Enter the desired name.
buttons.
button.
Change device name
button
Change device name