Replacing A Turn Signal Light Bulb; Supporting The Motorcycle - Yamaha TDM900 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1. Screw
2. Turn signal light lens
Replacing a turn signal light
bulb
1. Remove the turn signal light lens
6
by removing the screw.
2. Remove the defective bulb by
pushing it in and turning it counter-
clockwise.
1. Turn signal light bulb
3. Insert a new bulb into the socket,
EAU03497
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw.
CAUTION:
@
Do not overtighten the screw, other-
wise the lens may break.
@

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other mainte-
nance requiring the motorcycle to
stand upright. Check that the motor-
cycle is in a stable and level position
before starting any maintenance. A
strong wooden box can be placed un-
der the engine for added stability.
To service the front wheel
1. Stabilize the rear of the motorcycle
ECA00065
2. Raise the front wheel off the
6-37
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
der the frame in front of the rear
wheel.
ground by using a motorcycle
stand.
EAU01579