Rear Wheel - Yamaha TDM900 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
To install the front wheel
1. Lift the wheel up between the fork
legs.
2. Insert the wheel axle.
3. Lower the front wheel so that it is
on the ground.
4. Install the brake calipers by install-
ing the bolts.
NOTE:
_
Make sure that there is enough space
between the brake pads before install-
ing the brake calipers onto the brake
discs.
6
_
5. Install the brake hose holders by
installing the bolts.
6. Tighten the wheel axle, the front
wheel axle pinch bolt and the
brake caliper bolts to the specified
torques.
EAU04376
Tightening torques:
Wheel axle:
72 Nm (7.2 m·kgf)
Front wheel axle pinch bolt:
20 Nm (2.0 m·kgf)
Brake caliper bolt:
40 Nm (4.0 m·kgf)
7. Push down hard on the handlebar
several times to check for proper
fork operation.
1. Bolt (× 2)
2. Quick fastener (× 3)

Rear wheel

To remove the rear wheel
_
_
6-39
WARNING
G
It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motor-
cycle so that there is no danger
of it falling over.
EAU04455
EW000122