Yamaha TDM900 Owner's Manual page 85

After removal Before installation
1. Quick fastener
2. Pin
1. Remove the drive chain cover by
removing the quick fasteners and
the bolts.
PERIODIC MAINTENANCE AND MINOR REPAIR
1. Axle nut
2. Drive chain slack adjusting bolt
3. Locknut
4. Alignment marks
2. Loosen the axle nut and the brake
caliper bracket bolt.
3. Lift the rear wheel off the ground
according to the procedure on
page 6-39.
6-40
1. Bolt
2. Brake caliper bracket
4. Remove the axle nut.
5. Loosen the locknut on each side of
the swingarm.
6. Turn the drive chain slack adjust-
ing bolts fully in direction a.
7. Push the wheel forward, tighten
the caliper bracket bolt and then
remove the drive chain from the
rear sprocket.
NOTE:
_
The drive chain does not need to be
disassembled in order to remove and
install the rear wheel.
_
6