Cleaning The Air Filter Element And Check Hose - Yamaha DT125R Owner's Manual

Tightening torque:
Coolant drain bolt:
10 Nm (1,0 m•kgf)
8. Connect the coolant reservoir
hose.
9. Pour the recommended coolant
into the radiator until it is full.
Recommended antifreeze:
High quality ethylene glycol antifree-
ze containing corrosion inhibitors for
aluminum engines
Antifreeze/water mixing ratio:
1:1
Coolant quantity:
Radiator capacity (including all rou-
tes):
0,92 L (0,97 US qt)
Coolant reservoir capacity:
0,3 L (0,32 US qt)
CAUTION
If coolant is not available, use
distilled water or soft tap water
instead. Do not use hard water
or salt water since it is harmful
to the engine.
PERIODIC MAINTENANCE AND MINOR REPAIR
If water has been used instead
of coolant, replace it with coo-
lant as soon as possible, other-
wise the engine may not be
sufficiently cooled and the coo-
ling system will not be protec-
ted against frost and corrosion.
If water has been added to the
coolant, have a Yamaha dealer
check the antifreeze content of
the coolant as soon as possi-
ble, otherwise the effective-
ness of the coolant will be
reduced.
10. Install the radiator cap.
11. Run the engine several minutes.
Stop the engine and recheck the
coolant level in the radiator. If it is
low, add more coolant until it rea-
ches the top of the radiator.
ECA10470
12. Install the radiator cap stopper
bolt.
13. Fill the coolant reservoir with
coolant up to maximum level.
14. Install the coolant reservoir cap
and check for coolant leakage.
NOTE:
If any leakage is found, ask a Yamaha
dealer to inspect the cooling system.
15. Install the cowling and the panel.
Cleaning the air filter
element and check hose
The air filter element should be clea-
ned at the intervals specified in the
periodic maintenance and lubrication
chart. Clean the air filter element more
frequently if you are riding in unu-
sually wet or dusty areas. In addition,
the air filter check hose must be fre-
quently checked and cleaned if
necessary.
1. Screws (x3)
6-10
EAU20831
6
1