Download  Print this page

Checking The Front And Rear Brake Pads - YAMAHA DT125R Owner's Manual

2004.
Hide thumbs

Advertisement

Turn the adjusting nut while holding
the rear brake light switch in place. To
make the brake light come on earlier,
turn the adjusting nut in direction (a).
To make the brake light come on later,
turn the adjusting nut in direction (b).
Checking the front and rear
brake pads
FRONT
1. Wear limit indicator
The front and rear brake pads must
be checked for wear at the intervals
specified in the periodic maintenance
and lubrication chart. To check the
brake pad wear, measure the lining
thickness. If the lining thickness is
less than 0,8 mm (0,03 in), have a
Yamaha dealer replace the brake
pads as a set.
PERIODIC MAINTENANCE AND MINOR REPAIR
s WARNING
s
If a malfunction is noted, have a
Yamaha dealer check the system
before riding.
REAR
EAU22340
1. Wear indicator
1
Checking the brake fluid level
FRONT
1
1. Minimum level mark
Insufficient brake fluid may allow air
to enter the brake system, possibly
causing it to become ineffective.
EWA10250
Before riding, check that the brake
fluid is above the minimum level mark
and replenish if necessary. A low bra-
ke fluid level may indicate worn brake
pads and/or brake system leakage. If
the brake fluid level is low, be sure to
check the brake pads for wear and
the brake system for leakage.
Observe these precautions:
1
REAR
EAU22580
1. Minimum level mark
6-18
When checking the fluid level,
make sure that the top of the
brake fluid reservoir is level.
1
Use only the recommended qua-
lity brake fluid, otherwise the rub-
ber seals may deteriorate, cau-
sing leakage and poor braking
performance.
6

Advertisement

Table of Contents

   Also See for YAMAHA DT125R

This manual is also suitable for:

Dt125x

Comments to this Manuals

Symbols: 0
Latest comments:
  • alfred tap May 27, 2015 08:28:
    i have no comment regarding with the manual because i did'nt able to scroll down