SpectraLink 7710 User Manual page 71

Spectralink 7710, 7720, 7740 User Guide
Your telephone company may make changes in its facilities, equipment, operations, or procedures
that could affect the proper functioning of your telephone system, If they do and it is possible, you
will be notified in advance to give you an opportunity to maintain uninterrupted telephone service.
If you experience trouble with this telephone system, disconnect it from the network until the
problem has been corrected or until you are sure that the equipment is not malfunctioning.
Note
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to local regulations. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
•
connected.
Consult the dealer or an experienced radio/TV technician for help.
•
Hearing Aid Compatibility
This equipment is hearing-aid compatible, as defined in Section 68.316 of Part 68 FCC Rules.
FCC Note
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
SAR
Device has been tested for SAR compliance for head and body worn configurations. The highest
reported SAR value is: head 0.046 W/kg (7710/7720/7740) .
IC Note: Operation is subject to the following two conditions: (1) This device may not cause
interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
The Term "IC": before the certification/registration number only signifies that the Industry Canada
technical specifications were met.
Privacy of communications may not be ensured when using this telephone.
14184663 Version 8.0
September, 2013 69