Installing The 802.11N Wireless Router - Zoom 4402 User Manual

Installing the 802.11n
This chapter provides basic instructions for connecting the
hardware and configuring the 802.11n Wireless Router using the
Wizard. If you have already done this by following the
instructions in the printed Quick Start, skip to Chapter 2,
Advanced: Basic Settings.
Step 1: Connecting the Router to a Computer
1
Place the 802.11n Wireless Router near a computer to be
used for setup. That computer needs an Ethernet (LAN) port.
2
Turn off the computer.
3
Attach the antenna to the Router. (Remove the antenna from
the package. Screw-on the antenna into the mount on the
back panel of the router.)
4
Connect one end of the supplied Ethernet cable to the
computer's Ethernet port and the other end to any of the
802.11n Wireless Router's LAN ports.
5
Plug the supplied power cube into the 802.11n Wireless
Router, and then into a power outlet.
Important: Use only the power cube shipped with the
802.11n Wireless Router. Other power cubes may damage
the device.
6
Turn on the computer. The PWR LED
Wireless Router front panel should turn on. The connected
LAN port LED will become steady on.
7
If you want the 802.11n Wireless Router to have access to
the Internet, connect its WAN port to the Ethernet port on a
working cable modem, ADSL modem, or other broadband
8
Wireless Router
on the 802.11n
802.11n Wireless Router User Manual
1