Liebert DM User Manual page 37

30 Chapter 3 Electrical Installation
Analog main menu interface
Press the ENT key to enter the analog submenu interface when the current main interface shows 'F--' (the symbol of
analog main menu). The switching operation processes and orders of the analog submenu are shown in the following
figure.
Analog main menu
Current alarm main interface
Press the ENT key to enter the current alarm submenu interface when the current main interface shows 'A--' (the
symbol of current alarm main menu). The switching operation processes and orders of the current alarm submenu are
shown in the following figure.
See Table 6-3 for generating conditions and troubleshooting.
ENT key
- -
F
F01
DOWN key
F02
F03
F04
ESC key
F05
F06
Current alarm main
menu interface
ENT key
- -
A
- - -
or
No alarm
ESC key
- -
F
DM Series 16kW Air Conditioner User Manual
Analog submenu shows
the ID and values circulary
Initial interface
16.1
Analog ID definitions
16.1
F01: The maximum pressure between the
pressure 1 and pressure 2; 88.8 will be
.0
shown when the pressure sensor is disabled
F02: Pressure 1
-15
F03: Pressure 2
F04: Ambient temperature
60
F05: SCR temperature
F06: Output voltage percentage
88
UP key
When there is an alarm, the XX of
alarm ID is the number from 00
DOWN key
Current alarm ID definitions
AXX
A00: Phase loss alarm
A01: SCR over temperature
AXX
A02: Fan 1 over temperature
A03: Fan 2 over temperature
AXX
A04: Pressure sensor failure
A05: EEPROM read fault
AXX
A06: SCR temperature sensor failure
A07: Abnormal frequency
UP key