Liebert DM User Manual page 20

D
148
Figure 2-17 Mounting base dimensions for horizontal installation (unit: mm)
Table 2-3 Mounting base dimensions for horizontal installation (unit: mm)

Note
The installation holes are long and flat holes. It is recommended to use M10 × 20 bolts to fix the mounting base.
Mounting base for vertical installation
The mounting base for vertical installation is shown in Figure 2-18, and the dimensions of each model are listed in
Table 2-4.
Figure 2-18 Mounting base dimensions for vertical installation (top view) (unit: mm)
Table 2-4 Mounting base dimensions for vertical installation (unit: mm)
DMC16M2

Note
1. The installation holes are long and flat holes. It is recommended to use M10 × 20 bolts to fix the mounting base.
2. When one condenser needs to be installed on another one, the upper condenser must be installed on a rack and cushion pads
should be used between the condenser and the rack for damping. It is prohibited to stack two condensers and bolt them together
directly.
L'
B
Front view
Dimension
Model
(L' × H' × D)
DMC16M2 1126 × 837 × 53
a
20
Model
Liebert_DM 16kW Air Conditioner User Manual
Chapter 2 Mechanical Installation
D
D
Amplified part figure
Installation holes
(8 holes in total )
H'
D
Bottom view
148
Side view
B C
980 691
20
Amplified
part figure
D
D
C
Installation
hole (4 pcs)
Dimension 'a'
1280
13