Testing The System - ADT SAFEWATCH PRO User Manual

Using the The TEST key puts your system into the Test mode, which allows each protection point
to be checked for proper operation.
5 TEST Key
1. Disarm the system and close all protected windows, doors, etc. The touchpad's
NO ALARM REPORTS
WILL BE SENT TO THE
2. Enter your security code and press the TEST [5] key.
ADT CUSTOMER CARE
3. As the Test mode is entered, the external siren or bell will sound for one second and
CENTER WHILE THE
SYSTEM IS IN TEST
MODE.
4. Open and close each protected door and window in turn and listen for the required
NOTE:
The touchpad will sound
a single beep every 40
5. Walk in front of each interior motion detector (if used) and listen for the required
seconds as a reminder
that the system is in the
test mode.
6. Follow the manufacturer's instructions to test all smoke detectors, to ensure that all
7. After all protection points have been checked and restored, there should be no zone
8. Turn off the Test mode by entering the security code and pressing the OFF [1] key.

TESTING THE SYSTEM

(TO BE CONDUCTED WEEKLY)
READY message should be displayed and the READY indicator should be lit.
then turn off.
Each time a protection zone is faulted, the touchpad sounds 3 beeps.
sounds. The identification of each faulted protection point should appear on the
display.
sound as movement is detected. The identification of each detector should appear
on the display when it is activated.
N o t e : Wireless motion detectors (Passive Infrared units) will send signals out only if
they have been inactive for 3 minutes.
are functioning properly. The identification of each detector should appear on the
display when each is activated.
identification numbers displayed. If a problem is experienced with any
protection point (no confirming sounds, no display), CALL FOR
SERVICE IMMEDIATELY.
– 24 –