Other Trouble Displays - ADT SAFEWATCH PRO User Manual

TROUBLE CONDITIONS (Continued)
Words or letters in parentheses ( ) are those that are displayed on English Display
Other Trouble 1. COMM. FAILURE
Displays
*
Any "beeping" that
2. SYSTEM LO BAT
accompanies a
trouble display can be
stopped by depress-
ing any key on the
touchpad or by
entering an OFF
3. LO BAT + zone descriptor
sequence (code +
OFF)
**
Not all systems use
wireless transmitters.
4. MODEM COMM
5. BELL FAILURE
(or FC)
(or BAT with no zone No.)
(or BAT with zone No.)
(or CC)
(or CHECK 70)
–
Indicates that a failure has occurred in the telephone com-
munication portion of your system.
CALL FOR SERVICE IMMEDIATELY.
Indicates that a low system battery condition exists. Display
is accompanied by "beeping"* at the Touchpad. If this
condition persists for more than one day (with AC present),
CALL FOR SERVICE.
Indicates that there is a low battery condition in the wireless
transmitter** number displayed. Accompanied by a single
"beep" * (once every 40 seconds) at the Touchpad.
Either replace the battery yourself, or CALL FOR
SERVICE. If the battery is not replaced within 30 days, a
CHECK display may occur.
Indicates that the control is on-line with the Customer Care
Center's remote computer. The control will not operate
while on-line. Wait a few minutes. The display should
disappear.
Indicates that the wiring connection to the external sounder
is at fault (open or shorted). Accompanied by "beeping" at
the touchpad. CALL FOR SERVICE IMMEDIATELY.
–
27
Touchpads.
[