Arming Perimeter Only (Stay) - ADT SAFEWATCH PRO User Manual

Using the
3 STAY Key
BEFORE ARMING,
close all doors and windows
(see CHECKING FOR OPEN
ZONES on page 13).
THE STAY MODE ARMS
THE PERIMETER, BUT
ALLOWS USE OF THE
ENTRY/EXIT DOOR.
PERSONS WITHIN THE
PREMISES CAN MOVE
ABOUT FREELY.
† Ask your installer if this
feature is programmed in
your system. If so, place a
check in this box.
ARMING PERIMETER ONLY
WITH ENTRY DELAY ON
Use this key when staying inside, but expect someone to use an entry/exit door later. It is
also useful if you are leaving but someone is staying inside (or if you have pets which are
moving throughout the premises.
1. Enter your security code and press the STAY [3] key.
2. The touchpad beeps three times and displays the armed STAY message (see
displays below). The red ARMED indicator also lights. Note that there is an exit delay
in effect before arming actually takes place. See the note below.
3. After arming, an alarm sounds immediately if a protected perimeter window or non-
entry/exit door is then opened, but anyone may otherwise move freely throughout
the premises.
Anyone entering later can enter through an entry/exit door without causing an alarm, but
they must disarm the system within the entry delay period to avoid sounding an alarm.
†
Exit Delay Restart. If you wish to open the entry/exit door to let someone in after
arming STAY, you can re-start the exit delay at any time – simply press the [ ] key,
then let that person in. This avoids having to disarm the system and then re-arm it again.
N o t e : When you first arm in the STAY mode, "You may exit now" will be displayed on a
Custom Display Touchpad during the programmed exit delay. This delay is in
effect even when arming STAY. When the exit delay period ends, "You may exit
now" disappears and the system is fully armed in the STAY mode.
TYPICAL DISPLAYS – "ARMED STAY"
AC
STAY
ENGLISH DISPLAY TOUCHPAD
– 16 –
ARME D STAY
*** ***
YOU M AY E XIT NOW
CUSTOM DISPLAY TOUCHPAD