Fitting the loop handle
•
Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.
•
Fit the screw, securing plate and wing nut as shown in the
diagram.
•
Tighten the wing nut.
Fitting the trimmer head
When fitting the cutting attachment it is extremely important
that the raised section on the drive disc/support flange
engages correctly in the centre hole of the cutting attachment.
If the cutting attachment is fitted incorrectly it can result in
serious and/or fatal personal injury.
WARNING! Never use a cutting attachment
!
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
10 –
English
ASSEMBLY
Fitting the trimmer guard and
trimmer head
•
Fit the correct trimmer guard (A) for use with the trimmer
head.
Hook the trimmer guard/combination guard onto the fitting
on the shaft and secure with the bolt (L).
•
Fit the drive disc (B) on the output shaft.
•
Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
•
To dismantle, follow the instructions in the reverse order.
H
H
1151414-95 Rev. 1 2008-12-23