Assembly - Husqvarna TA320 Operator's Manual

CAUTION:
repair work on the machine
requires special training. This is
especially true of the machine's
safety equipment. If your machine
fails any of the checks described
below you must contact your
service agent. When you buy any
of our products we guarantee the
availability of professional repairs
and service. If the retailer who sells
your machine is not a servicing
dealer, ask him for the address of
your nearest service agent.
To do a check of the cutting attachment guard
WARNING:
attachment without an approved
and correctly attached cutting
attachment guard. Always use the
recommended cutting attachment
guard for the cutting attachment
that you use, see
on page 12 . If an incorrect or
faulty cutting attachment guard is
attached this can cause serious
personal injury.
The cutting attachment guard stops objects
that ejects in the direction of the operator. It
also prevents injuries that occur if you touch
the cutting attachment.
1. Stop the motor.
Introduction
This section describes how to assemble and
adjust the product.
WARNING:
assemble the product, read the
safety chapter and the assembly
instructions.
To install the cutting attachment
guard
1. Attach the correct cutting attachment
guard (A) for the trimmer head. Refer to
Accessories on page 12 .
2119 - 001 - 13.07.2023
All servicing and
Do not use a cutting
Accessories

Assembly

Before you
2. Do a visual check for damages, for
example cracks.
3. Replace the cutting attachment guard if it
is damaged.
Safety instructions for maintenance
WARNING:
instructions that follow before you
use the product.
• Always stop the engine/motor before you
do work on the cutting attachment. The
cutting attachment continues to move after
the throttle/power trigger is released. If you
have a gasoline operated product, remove
the spark plug cap from the spark plug.
If you have a battery operated product,
remove the battery. Make sure that the
cutting attachment has stopped fully before
you do work on it.
• Use only original spare parts for repairs.
• Keep the product away from children
SAVE THESE
INSTRUCTIONS
2. Put the cutting attachment guard onto the
fitting on the shaft.
3. Attach the cutting attachment guard with
the bolts (B).
B
Read the safety
A
9