Assembly - Husqvarna 330iK Operator's Manual

attached to the product. The harness
makes operation more efficient.
Safety instructions for maintenance
WARNING:
instructions that follow before you
do maintenance on the product.
• Remove the battery before you do
maintenance, other checks or assemble
the product.
• The operator must only do the
maintenance and servicing shown in this
operator's manual. Turn to your servicing
dealer for maintenance and servicing of a
larger extension.
• Do not clean the battery or the battery
charger with water. Strong detergent can
cause damage to the plastic.
• If you do not do maintenance, it decreases
the life cycle of the product and increases
the risk of accidents.
• Special training is necessary for all
servicing and repair work, especially for
To assemble the loop handle
1. Attach the loop handle onto the shaft
between the arrows.
2. Move the spacer into the slot of the loop
handle.
3. Install the screw and the knob. Do not
tighten too much.
4. Adjust the loop handle to an applicable
position.
5. Tighten the knob.
To assemble the two-piece shaft
1. Turn the knob to loosen the coupling.
2094 - 001 - 04.08.2023
Read the warning

Assembly

the safety devices on the product. If
not all checks in this operator's manual
are approved after you have done
maintenance, turn to your servicing dealer.
We guarantee that there are professional
repairs and servicing available for your
product.
• Only use original spare parts.
• Always use heavy duty gloves when you
repair the cutting attachment. The blades
are very sharp and can easily cause
injuries.
WARNING:
wash the machine, as water can
enter the electrical system or the
motor and cause damage to the
machine or short circuit.
SAVE THESE
INSTRUCTIONS
2. Align the tab of the cutting attachment (A)
with the notch of the coupling (B).
3. Carefully push the shaft into the coupling
until you hear a click.
Do not pressure
B
A
11