Scanning; Scanning Overview; Set The Scan-Resume Preference - Yaesu FT-8800R Operating Manual

Scanning Overview

The allows you to scan just the Memory channels via
FT−8800R
49), the entire operating band in
Programmable Memory Scan
monitor the station(s) on that frequency.
Scanning operation is basically the same in each of the above modes. Before you begin, take a
moment to select the way in which you would like the
pauses on a signal. (See

Set the Scan-Resume Preference

Two options for the
In this mode, scanning will pause on a signal it encounters, and will hold there for five
TIME
seconds. If you do not take action to disable scanning within five seconds, scanning will
resume even if the stations are still active. This is the default setting.
In this mode, scanning will pause on a signal it encounters. Two seconds after the carrier
BUSY
has dropped, scanning will resume.
To set the
Scan-Resume
1. Press the
2. Rotate the
3. Press the
desired
Scan-Resume
4. Press and hold in the
normal operation.
Yaesu FT-8800R Operating Manual (courtesy of W5JCK)
VFO Scan mode
(see page 27). It will pause on signals encountered, so you can
Set the Scan-Resume Preference
mode are available:
Scan-Resume
mode:
key momentarily to enter the
SET
knob to select
DIAL
knob momentarily, then rotate the
DIAL
mode (
TIME
DIAL
0.
(see page 48), or a portion of that band via
FT−8800R
on page 46.)
mode.
Set
.
Menu #34 SCAN
or ).
BUSY
knob for ½ second to save the new setting and exit to

SCANNING

(see page
Memory Scan mode
to resume scanning after it
knob to select the
DIAL
Page 46 of 83