Scan In Vfo Mode - Yaesu FT-8800R Operating Manual

HOME Priority
To activate
Priority Channel Dual Watch
1. Recall the
2. Now set the
3. Press and hold in the
display will remain on the
check the
4. Press and hold in the

Scan in VFO Mode

This mode allows you to scan the entire current operating band.
1. Select the
2. Press and hold in the
bandwidth for
, and
PMS-X
•
ALL
999.990 MHz.
•
PMS-X
frequency pair (where
Band Limits for VFO Mode
•
BAND
3. Press the
•
During scanning, the
option was selected, otherwise the
•
If a signal strong enough to open the squelch is encountered during
scanning, scanning will pause temporarily and the decimal point of the
frequency will blink during the pause.
•
Scanning will resume according to the
selected. See
Yaesu FT-8800R Operating Manual (courtesy of W5JCK)
channel you wish to use as the
Memory
for operation on a
FT−8800R
key for ½ second to activate the
HOME
Priority Memory Channel
key for ½ second to disable the
mode by pressing the
VFO
key for one second, then rotate the
scanning. Available selections are
VFO
.
BAND
: Scanning will sweep all frequencies between 108 - 520 MHz and 700 -
: Scanning will sweep frequencies within the currently-selected PMS
: Scanning will sweep frequencies only on the current band.
key momentarily to start scanning.
P-X
Set the Scan-Resume Preference
operation:
Priority
channel.
HOME
channel, but every five seconds the
for activity.
key, if necessary.
is PMS memory channel number). See
X
on page 27.
indicator appears on the display if the
indicator appears on the display.
P Sc
Scan-Resume
SCANNING
frequency.
mode. The
HOME Priority
FT−8800R
mode.0.
HOME Priority
knob to select the
DIAL
, ,
+-1MHz +-2MHz +-5MHz
Program
PMS-X
mode that was
on page 46 for details.
Page 48 of 83
will
, ,
ALL