Yaesu FT-8800R Operating Manual page 51

To Flag a Memory channel to be Scanned during Standard Memory
Scan:
This is the default setting, so you only need to complete these steps if you
previously changed this setting for this Memory channel.
1. Set the radio to the
2. Rotate the
Standard Memory Scan
3. Set the band for the selected
knob.
4. Press the
5. Rotate the
6. Press the
7. Press and hold in the
normal operation.
To configure the FT−8800R
This is the default setting, so you only need to complete these steps if you
previously changed this setting. This setting is stored separately for each
side of each Hyper Memory channel (see page 43).
1. Press the
2. Rotate the
3. Press the
DIAL
4. Press and hold in the
normal operation.
Yaesu FT-8800R Operating Manual (courtesy of W5JCK)
mode by pressing the
Memory
knob to select the channel which you wish to be scanned during
DIAL
.
Memory Channel
momentarily to enter the
SET key
knob to select
DIAL
knob momentarily, then rotate the
DIAL
DIAL
0.
for
momentarily to enter the
SET key
knob to select
DIAL Menu #35 SCAN M
knob momentarily, then rotate the
knob for ½ second to save the new setting and exit to
DIAL
0.
to the
Main
mode.
Set
Menu #37 SKP.MSM
knob for ½ second to save the new setting and exit to
Standard Memory Scan:
mode.
Set
.
DIAL
SCANNING
key, if necessary.
band by pressing the
.
knob to
DIAL
OFF
knob to .
MEM
Page 51 of 83
DIAL
.