Yaesu FT-920 Operating Manual page 26

(31) L Switch (A)
OCK
The [L ] switch locks the settings of the VFO-A
OCK
Tuning Dial and/or the Shuttle Jog. Press this switch
momentarily to lock the Tuning Dial; press and hold it
in for ½ second to lock the Shuttle Jog.
When either control is locked, the "L
below the "VFO-A" indicator on the display panel will
be illuminated.
(32) D Switch
ISPLAY
This switch changes the function of the VFO-B read-
out area of the display panel. In the normal mode,
the VFO-B frequency is displayed. When this button
is pushed, and you are operating in the MR (Memory
Recall) mode, any alphanumeric memos ("Alpha-
Tags") you have programmed will be substituted in
place of the frequency display on the VFO-B side.
Press this switch again to return to the frequency dis-
play mode.
(33) (VFO) A K B Switch
Pressing and holding this switch in for ½ second
causes the contents of VFO-A to be copied into VFO-
B, so that the two VFOs' contents will be identical.
24
(34) (VFO) A
Pressing this switch momentarily to swap the con-
tents of VFO-A with those of VFO-B.
(35) VFO/M
Pressing this switch changes frequency control be-
" indicator
OCK
tween the VFO and Memory systems.
Repeatedly pushing this switch causes frequency
control to toggle between the two systems.
(36) RPT Switch
Pressing this switch, while on 28 MHz in the FM op-
erating mode, causes a standard repeater shift (de-
fault: 100 kHz) to be applied to the operating fre-
quency during transmission; additionally, a
(subaudible) CTCSS encode tone (default: 88.5 Hz)
will be superimposed on your transmitted signal, for
accessing repeaters requiring it.
Both the CTCSS tone frequency and repeater shift
may be changed via the Menu system.
(37) DW Switch
Pressing this switch activates the Dual Watch fea-
ture.
B Switch
Switch
EM
FT-920 Operating Manual