Maintenance; Fuel Tank; Air Input Filter; Air Output /Lint Filter - L.B. White CP125CK Owner's Manual

USE ORIGINAL EQUIPMENT REPLACE MENT PARTS. Use of third-party or other alternate components will void warranty and
may cause unsafe operating conditions.
Fire or explosion hazard!
Never service heater while it is plugged in or while hot!

FUEL TANK

Flush every 200 hours of operation or as needed (See Long-
term Storage, page 11).
Screw
–
F F i i g g u u r r e e 9 9 Air Filter Access
AIR INTAKE FILTER
WASH AND DRY WITH SOAP AND WATER EVERY 500 HOURS
OF OPERATION, OR AS NEEDED.
- Remove screws along each side of heater using medium
Phillips screwdriver.
- Lift off upper shell.
- Remove fan guard.
- Wash or replace air intake filter.
- Reinstall fan guard and upper shell.
WARNING
Upper Shell
Air Intake Filter
Fan Guard
AIR OUTPUT FILTER, LINT FILTER
Air Output Filter
End Filter Cover
Lint Filter
Air Pressure Gauge
F F i i g g u u r r e e 1 1 0 0 – Filter Assembly
REPLACE EVERY 500 HOURS OF OPERATION OR ONCE A
YEAR
- Remove upper shell and fan guard (See Air Intake Filter
Figure 9).
- Turn air pressure gauge counter-clockwise and remove.
- Remove end filter cover screws using medium Phillips
screwdriver.
- Remove end filter cover.
- Replace air output and lint filter.
- Reinstall end filter cover and air pressure gauge.
- Reinstall fan guard and upper shell.

FAN BLADES

Set Screw
Motor Shaft
Flush
Fan Blade
Motor
F F i i g g u u r r e e 1 1 1 1 – Fan Assembly
CLEAN EVERY SEASON OR AS NEEDED
- Remove upper shell (See Air Intake Filter).
- Use M6 Allen wrench to loosen set screw which holds fan
blade to motor shaft.
- Slip fan blade off motor shaft.
- Clean fan blade using soft cloth moistened with kerosene
or solvent.
- Dry fan blade thoroughly.
- Reinstall fan blade to motor shaft.
- Place fan blade hub flush with end of motor shaft.
- Place set screw on flat of shaft.
- Tighten screw firmly (40-50 inch-pounds/4.5-5.6 N-m).
Reinstall upper shell.

MAINTENANCE

Screw
Air Intake Filter
4 12