Nozzle - L.B. White CP125CK Owner's Manual

MAINTENANCE (cont.)

NOZZLE

Spark Plug
Nozzle Adaptor
Burner Head
Fuel Line
Air Line
Nozzle Face
Nozzle
Nozzle Adaptor
F F i i g g u u r r e e 1 1 2 2 – – N N o o z z z z l l e e R R e e p p l l a a c c e e m m e e n n t t F F o o r r M M o o d d e e l l s s C C P P 1 1 2 2 5 5 CK K a a n n d d C C P P 1 1 7 7 0 0 CK K
CLEAN NOZZLE AS NEEDED
(For Models CP125CK and CP170CK only)
- Remove upper shell (See Air Intake Filter, page 12).
- Remove fan blade (See Fan Blades).
- Remove fuel and air line hoses from nozzle adaptor.
- Remove ignitor wire from spark plug.
- Remove spark plug from nozzle adaptor using medium
phillips screwdriver.
- Turn nozzle adaptor 1/9 turn(40°) to counter clock wise
and pull toward motor to remove. (See Figure 12)
- Place plastic hex-body into vise and lightlry tighten.
- Carefully remove nozzle from burner head using 5/8"
socket wrench.
- Blow compressed air through face of nozzle.
(this will remove any dirty in nozzle)
- Reinstall nozzle into nozzle adaptor until nozzle seats.
Tighten 1/3 turn more using 5/8" socket wrench.
(40~45 inch-pounds)
- Reinstall nozzle adaptor to burner head.
- Reinstall spark plug to nozzle adaptor.
- Attach ignitor wire to spark plug.
- Attach fuel and air line hoses to nozzle adaptor.
- Reinstall fan blade and upper shell.
4 13
Combustion Chamber
Screw
Ignitor Wire
Nozzle Adaptor
Combustion Chamber
Spark Plug
Nozzle Adaptor
Fuel Line
Air Line
Nozzle Face
Nozzle
Nozzle Adaptor
F F i i g g u u r r e e 1 1 3 3 – N N o o z z z z l l e e R R e e p p l l a a c c e e m m e e n n t t C C P P 2 2 1 1 0 0 CK K
(For Model CP210CK Only)
- Remove upper shell (See Air Intake Filter, page 12).
- Remove fan blade (See Fan Blades).
- Remove fuel and air line hoses from nozzle adaptor.
- Remove ignitor wire from spark plug.
- Remove spark plug from nozzle adaptor using medium
phillips screwdriver.
- Turn nozzle adaptor 1/8 turn (45°) to counter clock wise
and pull toward motor to remove. (See Figure 13)
- Place plastic hex-body into vise and lightly tighten.
- Carefully remove nozzle from adaptor-nozzle using 5/8"
socket wrench.
- Blow compressed air through face of nozzle.
(this will remove any dirt in nozzle)
- Reinstall nozzle into nozzle adaptor until nozzle seats
Tighten 1/3 turn more using 5/8" socket wrench
(40~45 inch-pounds)
- Reinstall nozzle adaptor to burner bracket
- Reinstall spark plug to nozzle adaptor.
- Attach ignitor wire to spark plug.
- Attach fuel and air line hoses to nozzle adaptor.
- Reinstall fan blade and upper shell.
Screw
Ignitor Wire
Bracket-Burner
Nozzle Adaptor