Connecting To A Gps In The Car - Phonak SmartLink+ User Manual

Connecting to a GPS in the car

While a TV set provides a constant audio signal, GPS devices
only send out audio information every few seconds or minutes.
SmartLink+'s permanent audio input setting has been developed
with exactly these products in mind.
To activate the permanent
audio input:
J Switch ON SmartLink+
by holding down one of
its 3 microphone buttons
for 2 seconds.
J Attach the adapter for
external connections to
the SmartLink+.
J Connect one end of the audio cable to the SmartLink+'s
adapter for external connections interface, and the other to
the audio output socket of the GPS.
J Switch ON the GPS.
If you leave the car, proceed as follows:
J Remove the audio cable and the adapter for external connections
from the SmartLink+.
J If you do not need the SmartLink+: switch OFF SmartLink+.
If you want to continue using SmartLink+: hold down the
Zoom or SuperZoom button for one second. This will switch
OFF the GPS mode and activate the microphones in SmartLink+.
25