DSP settings (KDC-X998, KDC-BT958HD)
5-7. Delay time control
Adjusting fine tuning of the speaker position
compensation value specified at
selection> (page
19).
Preparation for setting
• If you specify the distance from the center of the currently
set listening position to every speaker, the delay time will
be automatically computed and set.
1. Determine the center of the currently set listening
position as the reference point (• in the illustration shown
below).
2. Measure the distances from the reference point to the
speakers.
3. Calculate the differences between the distance of the
furthest speaker and other speakers.
4. Input the differences calculated in step 3 for individual
speakers.
5. Adjust gain for individual speakers. A sound image will be
shifted to the speaker with increased gain.
Example: When "Front" is selected as the listening position
(<5-6. Listening position setting> (page
Front L
Rear L
SW L
1
Press [SRC] and select a source other than
Standby ("STANDBY") using [Control] knob.
Refer to
<Source selection> (page
2
Press [Control] knob.
Enters the Function setting mode.
3
Select "Audio Control"
Settings"
>
"DTA" using [Control] knob.
For how to use [Control] knob, refer to
to select the item> (page
22
|
KDC-X998/ KDC-BT958HD/ KDC-X898/ KDC-BT858U
<5-3. Car type
21)).
+3.2 feet
Front R
1.7 feet
2.6 feet
Rear R
4.9 feet
+2.3 feet
+0 feet
SW R
14).
>
"Pro Setup"
>
"DTA
<3-3. How
13).
4
Select a speaker using [Control] knob.
Speaker
Display
Front Left speaker
"FrontL"
Front Right speaker
"FrontR"
Rear Left speaker
"RearL"
Rear Right speaker
"RearR"
Subwoofer Left
"SW L"
Subwoofer Right
"SW R"
(Colored
text: Factory setting)
5
Select a value using [Control] knob.
Exiting from the Function setting mode
Press and hold [1/6].
Range
0
– 20.01 feet
0
– 20.01 feet
0
– 20.01 feet
0
– 20.01 feet
0
– 20.01 feet
0
– 20.01 feet