Initial Settings - Kenwood KDC-X998 Instruction Manual

General settings

14-5. Initial settings

You can configure initial settings of this unit.
1
Press [SRC] and select a Standby ("STANDBY")
using [Control] knob.
Refer to <Source selection> (page
2
Press [Control] knob.
Enters the Function setting mode.
3
Select "Initial Settings" using [Control] knob.
For how to use [Control] knob, refer to
to select the item> (page
4
Select an Initial setting item using [Control]
knob.
Display Description
"SRC Select" Set source selection method.
"1": The source switches each time [SRC] is
pressed.
"2": Press [SRC], Turn [Control] knob to select
the source, and then press [Control] knob to
determine it.
"Key Beep" Setting the operation check sound (beep
sound) ON/OFF.
"ON" / "OFF"
"Function Language" Changes the display language of items
displayed in the Function setting mode.
"English" / "Français" / "Español"
"Pandora Source" Sets whether to display Pandora during source
selection.
"ON" / "OFF"
"iHeartRADIO Source" Sets whether to display iHeartRadio during
source selection.
"ON" / "OFF"
"aha Source" Sets whether to display aha during source
selection.
"ON" / "OFF"
"Built-in AUX" Sets whether to display AUX during source
selection.
"ON" / "OFF"
"CD Read" Sets the method for reading CD.
When unable to play a special format CD, set
this setting to "2" to force playing. Note that
some music CDs may be unplayable even
when set to "2".
In addition, audio files cannot be played when
set to "2". Normally, keep this set to "1".
1: Automatically distinguishes between the
audio file disc and music CD when playing
a disc.
2: Forces playing as a music CD.
"TAG Transfer Setup" When iPods are connected to both the front
and rear USB terminals, select the iPod to
which the tag stored through iTunes tagging is
to be transferred.
"FRONT" / "REAR"
66
|
KDC-X998/ KDC-BT958HD/ KDC-X898/ KDC-BT858U
14).
<3-3. How
13).
"Built-in AMP" Selecting "OFF" turns off the built-in amplifier.
Turning off the built-in amplifier improves the
quality of the sound from Preout.
"ON" / "OFF"
"Speaker Select"[1] Sets the speaker type so that the System Q
value is optimal.
"OFF": OFF
"5/4inch": For 5 & 4 in. speaker
"6x9/6inch": For 6 & 6x9 in. speaker
"O.E.M.": For the OEM speaker
"F/W Update" Upgrades the firmware.
Selecting "YES" and then pressing [Control]
knob starts upgrading the firmware.
For how to update the firmware, access our
web site.
www.kenwood.com/cs/ce/
text: Factory setting)
(Colored
[1]
Function of KDC-X898/ KDC-BT858U.
5
Select a setting using [Control] knob.
Returns to the previous item.
Exiting from the Function setting mode
Press and hold [1/6].