Hard Drive Connector - HP 15 Maintenance And Service Manual

Hard drive connector

Description
Hard drive connector
Before removing the hard drive connector, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
● Service door (see
● WLAN module (see
● Hard drive (see
●
Top cover (see
● System board (see
Remove the hard drive connector:
1. Remove the cable from the clips built into the computer chassis (1).
104 Chapter 4 Removal and replacement procedures
Battery on page 49), and then remove the following components:
Service door on page 55)
WLAN module on page
Hard drive on page 79)
Top cover/keyboard on page
System board on page
58)
61)
83)
Spare part number
747118-001