Hard drive connector
Description
Hard drive connector
Before removing the hard drive connector, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
●
Service door (see
●
WLAN module (see
●
Hard drive (see
●
Top cover (see
●
System board (see
Remove the hard drive connector:
1.
Remove the cable from the clips built into the computer chassis (1).
2.
Remove the hard drive connector (2).
Reverse this procedure to install the hard drive connector.
Battery on page
43), and then remove the following components:
Service door on page
49)
WLAN module on page
Hard drive on page
70)
Top cover/keyboard on page
System board on page
52)
55)
73)
Component replacement procedures
Spare part number
747240-001
91