Hard Drive Connector Board - HP 15 Maintenance And Service Manual

Hard drive connector board

Description
Hard drive connector board
Before removing the hard drive connector board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the optical drive (see
5. Remove the bottom cover (see
6. Remove the battery (see
7. Remove the hard drive (see
Remove the hard drive connector:
1. Disconnect the cable from the system board ZIF connector (1).
2. Remove the Phillips M2.0×3.0 screw (2) that secures the board to the computer.
3. Remove the board from the computer (3).
Reverse this procedure to install the hard drive connector board.
Optical drive on page
Bottom cover on page
Battery on page 40).
Hard drive on page 44).
33).
37).
Component replacement procedures
Spare part number
L20454-001
51