Hard Drive Connector Board - HP 250 G7 Maintenance And Service Manual

Hard drive connector board

Table 6-8 Spare part description and number
Description
Hard drive connector board
Before removing the hard drive connector board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the optical drive (see
3. Remove the bottom cover (see
4. Remove the battery (see
5. Remove the hard drive (see
Remove the hard drive connector:
1. Disconnect the cable from the system board ZIF connector (1).
2. Remove the Phillips M2.0 × 3.0 screw (2) that secures the board to the computer.
3. Remove the board from the computer (3).
Reverse this procedure to install the hard drive connector board.
44 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
(Preparation for disassembly on page
Optical drive on page
Bottom cover on page
Battery on page 34).
Hard drive on page 38).
29).
32).
Spare part number
L20454-001
28).