Optical Drive Connector Cable - HP Pavilion 17 Maintenance And Service Manual

Optical drive connector cable

Description
Optical drive connector cable
Before removing the optical drive connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Optical drive (see
b. Hard drive (see
c. WLAN module (see
d. Keyboard (see
e. Top cover (see
f. System board (see
Remove the optical drive connector cable:
1. Release the optical drive connector cable from the clips (1) and routing channel built into the
base enclosure.
2. Remove the optical drive connector cable (2).
Reverse this procedure to install the optical drive connector cable.
90 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 47), and then remove the following components:
Optical drive on page
Hard drive on page 49)
WLAN module on page
Keyboard on page 56)
Top cover on page 60)
System board on page
48)
52)
73)
Spare part number
720668-001