A Troubleshooting; Connect The Adsl Line; Connect The Power Adapter; Connect To The Barricade's Ethernet Port - SMC Networks Barricade SMC7401BRA User Manual

I
NSTALLATION

Connect the ADSL Line

Run standard telephone cable from the wall jack providing ADSL service
to the ADSL port on your Barricade. When inserting an RJ-11 plug, be
sure the tab on the plug clicks into position to ensure that it is properly
seated. If you are using splitterless ADSL service, be sure you add low-pass
filters between the ADSL wall jack and your telephones. (These filters pass
voice signals through but filter data signals out.)

Connect the Power Adapter

Plug the power adapter into the power socket on the rear of the Barricade,
and the other end into a power outlet.
Check the power (PWR) indicator on the front panel is lit. If the power
indicator is not lit, refer to Appendix A Troubleshooting.
In case of a power input failure, the Barricade will automatically restart and
begin to operate once the input power is restored.
If the Barricade is properly configured, it will take about 30 seconds to
establish a connection with the ADSL service provider after powering up.
During this time the Sync indicator will flash. After the ADSL connection
has been established, the ADSL Sync LED will stay on.

Connect to the Barricade's Ethernet Port

Connect directly to a PC or server equipped with an Ethernet network
interface card using the cable supplied with the Barricade. However, when
connecting the Barricade to a network device such as an Ethernet hub or
switch, use a crossover cable to connect to an MDI port on the other
device, or use the supplied straight-through cable to connect to an MDI-X
(i.e., with internal crossover) port on the other device. Refer to Appendix
B for detailed information on these wiring types. If you connect the
Barricade to a network device, then you need to connect your PCs to that
device. When inserting an RJ-45 plug, be sure the tab on the plug clicks
into position to ensure that it is properly seated.
2-6