Cables; Ethernet Cable; Specifications; Wiring Conventions - SMC Networks Barricade SMC7401BRA User Manual

Ethernet Cable

Caution: Do NOT plug a phone jack connector into any RJ-45 port. For

Specifications

Cable
10BASE-T
100BASE-TX Cat. 5 100-ohm UTP

Wiring Conventions

For Ethernet connections, a twisted-pair cable must have two pairs of wires.
Each wire pair is identified by two different colors. For example, one wire
might be red and the other, red with white stripes. Also, an RJ-45 connector
must be attached to both ends of the cable.
Each wire pair must be attached to the RJ-45 connectors in a specific
orientation. The following figure illustrates how the pins on the RJ-45
connector are numbered. Be sure to hold the connectors in the same
orientation when attaching the wires to the pins.
Figure B-1. RJ-45 Connector Pin Numbers
Ethernet connections, use only twisted-pair cables with RJ-45
connectors that conform to FCC standards.
Cable Types and Specifications
Type
Cat. 3, 4, 5 100-ohm UTP
A
PPENDIX
C
Max. Length
100 m (328 ft)
100 m (328 ft)
B
ABLES
Connector
RJ-45
RJ-45
B-1