Presetting And Recording Of Time Code - JVC GY-DV5100 Instructions Manual

10. TIME CODE OPERATION

10-2 Presetting and Recording of Time Code

The time codes from the internal time code generator can be recorded at the time of recording scenes.
Whether or not user's bit data should be recorded can be selected with the UB REC item on the TC/UB/CLOCK menu screen.
OPEN
LCD BRIGHT DISPLAY
AUDIO
LEVEL PULL
OPEN
FRONT
REAR
CH-1 CH-2
CH-1 CH-2
AUDIO IN
AUDIO SELECT
CH-1 CH-2
AUTO
MANUAL
TC/UB/CLOCK menu screen
––– TC/UB/CLOCK –––
TC PRESET 00:00:00:00
EXECUTE
UB PRESET 00 00 00 00
EXECUTE
UB REC ON
HEADER REC..
TIME/DATE..
PAGE BACK
E-68
LCD BRIGHT DISPLAY
MONITOR
SELECT
COUNTER
CH-1
MIX FRONT TC
CH-2 REAR
UB
AUDIO
CH-1 CH-2
CH-1 CH-2
LEVEL
AUDIO IN
REAR
AUDIO SELECT
AUDIO IN
FRONT MIC +48V
CH-1 CH-2 TC GENE.
CH-1 CH-2
AUTO
LINE PRST FREE
ON OFF
MANUAL REC
MIC
+48V
REGEN
TC GENE. switch
To preset the Time Code, make the following settings.
■ TC GENE. switch
Set to PRST REC or PRST FREE.
PRST REC : The data preset in the time code generator
runs only during recording.
Use this setting if it is necessary to record
continual time codes across different
scenes.
* However, approximately ±1-frame
variations may occur in scene accuracy.
PRST FREE : The time code starts to run from the time it
is preset in the time code generator.