Table of Contents
Advertisement
6.3 Electrical connection
Pay attention to the rating plate data.
If damaged, the mains cable must be replaced by a
special mains connecting cable. The mains
connecting cable must only be connected by the
manufacturer or the manufacturer's after-sales
service.
When connecting the power supply cord to the
receptacle located below the cooktop surface, the
cord is to be:
– Routed beneath the appliance; and
– Routed away from heat generated by the cooktop.
Pay attention to the following notes if you
wish to install a gas range next to the hob
ventilator.
– A locking bolt must be installed in the hob
ventilator to prevent the boom from swivelling
over the gas range.
– Extend the unit.
– Position the swivel arm in the centre.
– Open the flap on the rear.
– Fit a pin (accessory) in the collar of the acces-
sible mounting ring (black plastic part). Fit the
pin on the side opposite to the one where the
boom is no longer to swivel.
– Close the flap.
When operated next to gas appliances, the swivel
arm must be extended at least to the top edge of
the pan as otherwise the flame of the gas burner
will be impaired.
After installation, plug the connecting cable plug
in an accessible socket. If the plug can no longer
be removed after installation, isolation of all poles
from the mains must be ensured by means of an
accessible isolator with a contact spacing of at least
3 mm.
You can use the window switch if the appliance
is only used when the window is open (to ensure
adequate incoming air).
A switch (normally open contact) is fitted on the
window. This switch is connected to the window
switch terminal on the main electronics. The
appliance can now only be operated when the
window is open.
Important: the window switch must only be
connected by an authorised specialist.
VL 051-707
/01
AC 120V / 60Hz
FD xxxx
xxxxxx
max 300W
2.2A
13
Advertisement
Table of Contents
