CYBEX 8800 Owner's Manual page 18

Strength systems
Hide thumbs Also See for 8800:
Table of Contents

Advertisement

B.
Carefully place frame on fl oor.
C.
Carefully place rubber feet (supplied with machine) on each foot of the frame.
5. Securely anchor machine to the fl oor.
A.
Securely anchor machine to the fl oor using the anchor holes provided in each machine.
NOTE: Cybex is not responsible for the actual anchoring of equipment. Consult with a professional contractor.
NOTE: Use fasteners having a minimum of 500 lbs tensil capacity (3/8" grade 2 bolts or better).
NOTE: If legs/frame does not contact surface, DO NOT pull down with anchors. Shim any leg or frame not in
contact with surface using fl at washers.
6. Install weight plates.
A.
Using a 7/32" Allen wrench, remove the two Button
Head Socket Cap Screws (BHSCS) securing the
top cap to the frame. See Figure 1.
B.
Remove top cap and BHSCS and set aside.
C.
Carefully lift shroud up and out of machine.
D.
Slide spring loaded guide rod cap down guide
rod until cap is clear of frame. NOTE: Guide rod
cap is spring loaded.
E.
Slowly release grasp
of guide rod cap.
See Figure 2. NOTE:
Guide rod cap
contains a
compression spring
that will fl y if grasp is
not released slowly.
F.
Remove guide rod
cap and spring and
set aside.
G.
Repeat steps 6D - 6F
for other guide rod.
4-2
Product Number 8800/8810/8830/8840 Owner's Manual
Guide
Rod Cap
Compression
Spring
Figure 2
BHSCS
Top Cap
Figure 1
Compression
Spring
Guide Rods
Shroud
Guide
Rod Cap

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

883088408810

Table of Contents