Remote Access Code; Message Alert Tone - VTech CS6328-2 User Manual

Answering system settings

remote access code

A two-digit security code is required to access the answering system
remotely from any touch-tone telephone. The preset code is 19. You can set
the code from 00 to 99.
Press MeNU/
1.
VOL/
2. Press
/SeLeCT.
MeNU
VOL/
3. Press
/SeLeCT.
MeNU
VOL/
4. Press
/SeLeCT.
MeNU
5. Press the dialing keys (0-9) to enter the code or
select from 00 to 99, then press

Message alert tone

This telephone can beep every 10 seconds to alert you of new messages.
The tone stops when all new messages have been reviewed.
Press MeNU/
1.
VOL/
2. Press
/SeLeCT.
MeNU
VOL/
3. Press
/SeLeCT.
MeNU
VOL/
4. Press
/SeLeCT.
MeNU
VOL/
5. Press
/SeLeCT to confirm your selection.
MeNU
• The answering system must be turned on for the message alert tone
to function.
Press any key on the telephone base (except /FIND hANDSeT) to temporarily
•
silence the message alert tone.
when the handset is not in use.
SeLeCT
to select > ANSWerING SYS, then press
VOL/
or
CID
to select > ANS SYS SeTUP, then press
VOL/
or
CID
to select > reMOTe CODe, then press
VOL/
or
CID
when the handset is not in use.
SeLeCT
to select > ANSWerING SYS, then press
VOL/
or
CID
to select > ANS SYS SeTUP, then press
VOL/
or
CID
to select > MSG ALerT TONe, then press
VOL/
or
CID
VOL/ to choose ON or OFF, then press
or
CID
/SeLeCT to confirm.
MeNU
16
VOL/ VOL/
or to
CID