Husqvarna SG 13 B Operator's Manual page 29

5. Tilt the machine on its wheels, lifting the cutting
wheel off the ground.
6. Hold in the OP grip bar and start the engine.
7. Allow the engine to warm up for two minutes at
idle before grinding.
8. Set the handle throttle to FAST to engage clutch.
9. Place the middle of the cutting wheel
approximately 1" (2.5 cm) above and ¾" to 1½"
(2-4 cm) into the stump.
10. Place the cutting wheel in the upper front edge of
the stump. Swing the cutting wheel from side to
side while lowering it about 1" (2.5 cm) after each
pass until the front edge of the stump is gone.
IMPORTANT INFORMATION
If the cutting wheel is too low, the machine
may start to "climb" over the stump and
become unstable.
30 -
HUSQVARNA
OPERATION
8060-200
8060-027
8011-203a