Husqvarna SG 13 B Operator's Manual page 16

13. Push throttle control lever on console forward to
full extent. Pull throttle control lever on engine
back as far as possible. Insert "L" end of throttle
cable into the outside hole of the engine throttle
control lever.
14. Attach the throttle cable to the engine using the
double wire clamp removed previously.
15. Test throttle control by pulling back throttle handle
on console. Throttle arm on engine should be
pushed completely forward. Cable should not slip
in clamp when doing this test.
16. Test proper wire length by pulling on the handle
adjustment lever and raising and lowering the
handle to maximum position without any pull on
harness.
17. Reattach air cleaner to engine.
18. Remove unit from pallet.
SET-UP
ENGINE
THROTTLE
CONTROL LEVER
THROTTLE
CABLE
FORWARD
THROTTLE
CABLE
HUSQVARNA
-17