Set-Up - Husqvarna SG 13 B Operator's Manual

1. Remove crate top and sides.
2. Remove upper handle bar assembly and lay aside.
3. Open bag containing loose hardware.
4. Using four (4) screws, flat washers and nuts attach
the upper handle bar assembly to lower handle
bar assembly.
NOTE: Handle fit is tight. When aligning holes use
a tapered type pilot to help align holes (i.e. punch
or phillips style screw driver).
5. Attach the position adjusting rod to bracket on the
upper handle bar assembly with the washers and
cotter pins placed above the rod bracket. Attach
the lower adjustment bar to the unit and secure
with cotter pin.
6. Assemble the compression spring, two (2) flat
washers and yoke to brake rod assembly.
7. Screw yoke onto the rod assembly until rod is
even or through threaded portion of yoke about ¼"
(6.35 mm).
8. Attach brake rod assembly to brake handle on the
upper handle bar assembly.

SET-UP

UPPER HANDLE BAR
ADJUSTING ROD
WASHERS
NUT
BRAKE ROD ASSEMBLY
COTTER PINS
WASHERS
LOWER
HANDLE BAR
YOKE
SPRING
BRAKE
HANDLE
-15
HUSQVARNA