Cyclone Filter - Husqvarna SG 13 B Operator's Manual

Cyclone Filter

The cyclone filter collects the largest contaminant
particles, which collect in the container. When you can
see a layer of dirt at the bottom of the container, the
cyclone housing (1), air channels and air intake screen
(2) must be cleaned.
Remove the three screw holding the cyclone housing.
Remove the housing with the air intake screen and
remove the air channels.
The air channels may remain in the upper portion or
follow along with the housing when removed.
IMPORTANT INFORMATION
Exercise care when reassembling to avoid
damage.
Make sure when mounting that the air intake
screen fits exactly in its guide in the upper
portion.
Make sure the air channel ends up in the
proper position.
Clean the components, using warm water, mild
detergent and a sift brush. Dry carefully.
Refit the components. Place the air channels in the
cyclone housing. Insert cyclone housing into position
and make sure it fits in the upper portion. DO NOT
use force; rather coax it into place before refitting the
screws.
34 -
HUSQVARNA
MAINTENANCE
1
2
8011-126
8011-213
8011-212