Self-Diagnosis - DeLonghi W SERIES Instruction Manual

P
ROGRAMMIN THE TIMER
The appliance can be programmed to start up and shut down
when required.
Programming start up
• Press the ON button.
The start-up time and message "ON TIMER" flash on the remo-
te control display (fig. 31).
• Press the or
ce to start up.
• When that time is reached, press the SET button to confirm
(fig. 32). The message "ON TIMER" appears on the remote con-
trol display and the
to indicate that the timer is active.
Programming shutdown
• Press the OFF button. The shutdown time and message
"OFF TIMER" flash on the remote control display (fig. 33).
• Press the or
ce to shut down.
• When that time is reached, press the SET button to confirm
(fig. 34). The message "OFF TIMER" appears on the remote
control display and the
ce to indicate that the timer is active.

SELF-DIAGNOSIS

The appliance has a self diagnosis system to identify a number of malfunctions.
Error messages are displayed on the appliance display.
I ... ,
F IS DISPLAYED
L T
OW EMPERATURE
(frost prevention)
P F
ROBE AILURE
(sensor damaged)
This message could appear in
heating mode if the condensate
drain hose is not attached or is
blocked.
F 1
Attach the hose or remove the
AILURE
obstruction.
(pump failure)
buttons to set the time you want the applian-
symbol is displayed on the appliance
buttons to set the time you want the applian-
symbol is displayed on the applian-
WHAT SHOULD I DO
The appliance is fitted with
a frost protection device to
avoid excessive formation
of ice. The appliance starts
up again automatically
when the defrosting pro-
cess is completed.
If this is displayed, contact
your local authorised servi-
ce centre.
34
? I ...
F IS DISPLAYED
H L
IGH
(tank full)
C
LEAN
After descaling or if the alarm reappears too soon after
the last descaling (carried out before the message is dis-
played), reset the alarm by holding the
for 10 seconds.
35
31
32
33
,
WHAT SHOULD I DO
Empty the internal safety
tank, following the instruc-
tions in the "End of season
operations" paragraph.
If this reoccurs, contact
your local authorised servi-
EVEL
ce centre. In heating
mode, attach the conden-
sate drain hose.
This message appears after
about 500 hours of opera-
tion in water mode and indi-
cates that the appliance
requires descaling as descri-
bed in the "descaling" para-
graph.
?
button down