Fan Mode; Heating Mode (Model L20H Only); Setting The Timer - DeLonghi Pinguino PAC L10 Instruction Manual

FAN MODE

Adjust fan speed by pressing the FAN button (P) as described for the air-conditioning mode.
Remember that the higher the speed, the more air is filtered. If you select "Quiet" speed, less air is
filtered but the appliance is also less noisy.
In this mode, AUTO cannot be selected.
The fan speed selected will be displayed.

HEATING MODE (MODEL L20H ONLY)

To set operation of the appliance correctly, press the "+" (F) or "-" (I) buttons until the desired tem-
perature is displayed.
In heating mode, the fan speed is selected automatically by the appliance.
The "AUTO" light (O) on the control panel comes on.

SETTING THE TIMER

The timer can be used to delay appliance start up or shut down. This avoids wasting electricity by
optimising operating periods
How to programme delayed start up
• Plug the appliance into a mains socket and press the ON/OFF (A) button, then select the requi-
red operating mode and other settings (temperature, fan speed, etc).
• Press the ON/OFF (A) button again to place the appliance in standby mode.
• Press the timer button (Q). The two centre segments flash on the display.
• Use the "+" (F) o "-" (I) buttons to set the number of hours delay before the appliance comes
on. The setting is increased or decreased by an hour at a time; however, when the buttons are
held down for more than two seconds, the time runs rapidly up to a maximum of 24 hours. Wait
a few seconds for the data to be acquired.
The indicator light (G) flashes until the appliance starts up.
You can set the appliance to come on with a delay of up to 24 hours.
To cancel the timer setting, press the timer button (Q), and use the "-" button (I) to set the time to
zero. The indicator light (G) will stop flashing.
How to programme delayed shut down
• Delayed shut down can be programmed in any operating mode (air conditioning / fan / hea-
ting) (model L20H only).
• Press the timer button (Q). The two centre segments flash on the display.
• Use the "+" (F) o "-" (I) button to set the number of hours delay before the appliance goes off.
The setting is increased or decreased by an hour at a time; however, when the buttons are
held down for more than two seconds, the time runs rapidly up to a maximum of 24 hours. Wait
a few seconds for the data to be acquired.
The indicator light (G) flashes until the appliance shuts down.
To cancel the timer setting, press the timer button (Q), and use the "-" button (I) to set the time to
zero. The indicator light (G) will stop flashing.
L10/ L15/ L20H operation
25