Table of Contents
Advertisement
TURNING THE APPLIANCE ON
Plug the appliance into the mains.
Press the ON/OFF button (17) (when turned on, the air conditioning unit starts operating in the
same mode as when it was turned off).
Press the MODE (18) button to select the required mode
AIR-CONDITIONING (COOL)
FAN ONLY (FAN)
An arrow on the display indicates the selected mode.
AIR-CONDITIONING MODE (COOL)
Ideal for hot humid weather when you need to cool and dehumidify the room.
In air-conditioning mode, use the buttons
The display shows the set temperature.
To change the fan speed, use the FAN button (16) on the remote control, choosing from the avai-
lable speeds:
LOW:
for silent operation
MED:
reduces noise levels but still maintains a good level of comfort
HIGH:
the air conditioning unit operates at maximum to reach the required temperature as
rapidly as possible
AUTO: the appliance automatically selects the most suitable fan speed in relation to the tem-
perature set on the digital display.
The most suitable temperature for the room during the summer varies from 24 to 27°C.
You are recommended, however, not to set a temperature much below the outside temperature.
FAN MODE ONLY
In fan mode, the fan speed can be set by pressing the FAN button (16).
The fan speed changes between the speeds available (LOW/MED/HIGH).
An arrow on the display indicates the set speed.
Remember that the higher the speed, the more air is filtered. If you select "LOW" speed, less air is
filtered but the appliance is also less noisy.
In this mode, AUTO cannot be selected.
SETTING THE TIMER
The timer can be used to delay appliance start up or shut down. This avoids wasting electricity by
optimising operating periods.
Programming delayed shutdown
• With the air-conditioning unit on, press the TIMER button. The time is displayed and the "h" sym-
bol flashes, with a flashing arrow indicating "TIMER OFF".
• Set the time when you want the appliance to go off using the
24 hours). During the first ten hours, you can select half hour intervals.
For times greater than ten hours, one hour intervals can be selected.
• Press the TIMER button again to confirm the selection.
(A beep sounds and the timer light (S) on the control panel comes on to confirm the setting of
the timer). A countdown of the time left is displayed.
At the end of the set time the appliance switches off automatically.
• To cancel the set time, press the TIMER button again: a beep will sound and the light (S) on the
control panel will go off.
28
L30/L40 operation
to select the desired temperature.
buttons (from 30 minutes to
Hide quick links:
Advertisement
Table of Contents
