Electrolux EOC633 Instructions For Use Manual page 41

SIMPRD 342-1-483 1/3/06
GAS INSTALLATION INFORMATION
G a s C o n n e c t i o n
Before commencing installation, check
to ensure the type of gas to which the
appliance is intended to be connected
matches the gas type given on the
appliance data plate.
Check the data plate (located behind the
oven door) to determine gas type. A gas
type label is located on the back panel
near the gas inlet.
A 1700mm long flexible hose is attached
to the inlet fitting at the rear of the
appliances.
A p p l i a n c e s f o r o p e r a t i o n o n N . G . & S . N . G .
For N.G. and S.N.G appliances the supplied N.G. regulator must be fitted. For L.P.G appliances
(Propane or Universal LP) the test point fitting supplied must be fitted.
NOTE: The inlet of the regulator or test point fitting should be fitted to the consumer piping first.
The arrow on the regulator or test point fitting indicates the direction of gas flow. Then connect
the hose to the outlet of the regulator or test point fitting using the swivel connection on the
hose and fibre washer supplied.
Ensure the regulator or test point fitting is in a position that is accessible with the
appliance installed and which will allow the appliance to be withdrawn without
disconnecting the hose.
Check all joints and ensure that connections are sound.
Important:
(P/No. 115-009-011)
11:00 AM Page 41
Flat fibre washer
must be installed
Retaining clips.
Use these clips to secure
hose and prevent
kinking.
Route flexible hose
through right or left
hand retaining clips.
Internal
Flange
NG Regulator
(P/No. 294-001-029)
41