Cleaning The Oven/Grill Door; Cleaning The Oven/Grill Accessories - Electrolux EOC633 Instructions For Use Manual

SIMPRD 342-1-483 1/3/06
CLEANING YOUR APPLIANCE
C l e a n i n g y o u r o v e n / g r i l l d o o r
NOTE: Side opening door models.
This door is not designed to be removed by the user. To allow for
access to the oven for cleaning the door need only to be fully
opened.
Removing the door from your appliance
Follow these steps to better access the oven for cleaning:
• Open door fully.
• Rotate the two stirrups forwards so that they are engaged
together onto the hooks on the hinge arms.
• Hold both stirrups in place and slightly close the door.
The stirrups will now remain engaged.
• Close the door half way and lift it away from the oven.
• Do not lift the door by the handle, use one hand either
side of the door, keeping fingers clear of the hinge arms.
Replacing the door to your appliance
• Relocate both hinge arms at the same time into the front housing.
• Ensure that the location notches on the bottom of the hinge arms are positioned onto the
lower cutout lip.
• Close the door partially to ensure that the location notch drops into place.
• When the hinges are located, open the door fully and ensure the stirrups are disengaged.
NOTE: Never use force and always ensure that the location notch is correctly engaged before
you operate the door.
IMPORTANT: Never lift or carry the door by the handle.
Do not immerse the door in water.
C l e a n i n g y o u r o v e n / g r i l l a c c e s s o r i e s
Removing the dishes and shelves from your
appliance
• Slide the dish and shelves towards you until
they reach the front stop.
• Tilt them up at the front to clear the side
supports, taking care not to spill the contents.
• Lift them clear.
• Wash the dish and insert the shelves in hot
soapy water.
• Reverse the above steps to put the grill dish
and shelves back again.
• Ensure that they are placed between the 2
support wires.
30
11:00 AM Page 30
Removing the side racks (shelf supports)
• Grasp the shelf supports at the front.
• Pull them firmly inwards.
• To install the shelf supports, first insert the
rear hook to the rear hole.
• Then locate the front peg into the front hole
and push in firmly.
NOTE: Dish support wires to be on top (as
shown in diagram).
Stirrup
Location Notch