Before Operating Your Appliance For The First Time; Setting The Time; Preparing Your Appliance For The First Time - Electrolux EOC633 Instructions For Use Manual

SIMPRD 342-1-483 1/3/06

BEFORE OPERATING YOUR APPLIANCE FOR THE FIRST TIME

S e t t i n g t h e t i m e ( i n i t i a l p o w e r u p o r a f t e r p o w e r f a i l u r e )
Depending upon which model you have purchased, your appliance maybe fitted with an
electronic / programmable timer. You must set the time of day before you can operate your
appliance.
2 button electronic clock
After the appliance has been switched on "0.00" and "AUTO"
will alternately flash on the clock display.
1. Press buttons – and + at the same time. "AUTO" will begin
flashing and you now have 4 seconds to start setting the time
of day or you will have to start the process again.
2. Enter the time of day in hours and minutes by pressing the –
or + buttons. Once the time has been entered, the clock
advances minute by minute.
NOTE: The clock has a 24-hour display.
3 button programmable clock
After the appliance has been switched on "12.00" will be
displayed and the "clock indicator"
1. To set the time of day in hours and minutes, press the – or +
buttons. 5 seconds after the last change, the "clock indicator"
will disappear, confirming the time has been set. Once the
time has been entered, the clock advances minute by minute.
NOTE: The clock has a 24-hour display.
CHEFLOGIC programmable controller
After the appliance has been electrically connected, the
set "clock symbol"
on the clock display, along with the scrolling message
"Welcome to Electrolux".
1. To set the time of day in hours and minutes press the
– or + buttons. 5 seconds after the last change the
timer arrow
has been set. Once the time has been entered, the
clock advances minute by minute.
NOTE: The clock has a 24-hour display.
P r e p a r i n g y o u r a p p l i a n c e f o r t h e f i r s t t i m e
Please remove all stickers and leaflets from the floor of the oven before operation.
Please wipe out the oven interior prior to operation with warm soapy water and polish dry with a
soft clean cloth. Do not close the oven door until the oven is completely dry.
New appliances have a smell during first use. It is recommended to operate the oven empty at a
temperature of 180°C for approximately 4 - 8 hours to eliminate the smell of the adhesive used in
the insulation. Please ensure the room is well ventilated during this process.
If your appliance is fitted with a 2-hour "AUTO OFF" timer, make sure it is set to the "OFF" position
for manual operation.
12
11:00 AM Page 12
and "timer arrow"
will disappear, confirming the time
will flash.
will flash
AUTO OVEN OFF
Stop
Push Both
PROGRAM TIMER
cook time
end time
+
— MODE
timer
clock