Signals For Users - Electrolux EIW63810X User Manual

11.Turn on the power switch
12.Immediately press the light icon and
keep it pressed until LEDs start
scanning
If the power LED became steady,
please repeat the two last steps until
LEDs start scanning
13.Wait for the power LED to flash, then
press the power icon until the LEDs
start scanning again
Some water will be dispensed from
the water dispenser automatically
14.Wait for the power LED to flash, then
remove the cleaning cartridge
Water may come out from the
cleaning cartridge.
If there is water on the base, dry it
carefully.

Signals for users

Signals for users on the front panel
Power LED
Filter LED
CO₂ bottle LED
Six LEDs alarm
LED type
15.Insert the filter cartridge in the filter
head by pushing it up and rotating it
counter-clockwise
16.Press the power icon until LEDs start
scanning again
17.Wait for the power LED to flash, then
press the power icon until all LEDs
start scanning.
Wait for all LEDs to turn off before
proceeding with the next step
Some water will be dispensed from
the water dispenser automatically
18.Close the water discharge tap and
reinsert the safety screw
19.Restart the appliance using the power
switch
20.Push back the appliance until it is
locked into position
21.Dispense 3 litres of cold still water
22.Dispense 1 litre of cold sparkling water
23.Dispense all ice shards
Message
Flashing LED:
• Appliance preparation to start-up
Steady LED:
• Power on signal
Flashing LED:
• There are 40 litres left before a new filter
cartridge is needed
Steady LED:
• Change the filter cartridge, there are 5 litres
left before safety lock of the appliance
• Check "Maintenance and cleaning" chapter
Steady LED:
• Cold sparkling water is disabled
• CO₂ bottle is empty or missing
• Check "Maintenance and cleaning" chapter
6 flashing LEDs (except filter and CO₂ bottle)
Check "What to do if..." chapter
electrolux 17