Electrolux EIW63810X User Manual page 12

Refreshment centre
Table of Contents

Advertisement

12 electrolux
First Start-up
Warning Dispense 3 litres of cold still
water and 1 litre of cold sparkling
water to rinse out well the water coils
Turn on the appliance using the power
switch placed on the right side of the
appliance.
The power LED will start flashing.
When the power LED stops flashing, the
touch control panel becomes active.
When using the Refreshment Centre for
the first time you need to wait 5 hours
before the appliance provides full
operating results.
During this period of time the
appliance is working but with limited
performance.
The above procedure needs to be
followed also after extended inactive
period of time.
Regulate water inlet pressure
Warning The pressure reducer must
be opened only when the installation
process is complete and the appliance
is switched on
1
Water plastic knob
2
Water pressure gauge
Make sure that the tap between the water
mains and the flexible hose is open.
After any pressure regulation, verify the
new adjusted level by dispensing a little
water.
Pressure has to be regulated between 2
and 3 bar operating on the plastic knob.
To regulate the pressure, pull up the water
plastic knob.
While dispensing ambient water: for
pressure increase rotate the knob
clockwise, for pressure decrease rotate it
counter-clockwise.
Once the regulation has been made, push
the knob back to its security position.
Regulate CO₂ pressure
Warning The pressure reducer must
be opened only when the connection
process is complete and the appliance
is powered up
Warning When changing CO₂
pressure, the adjusted sparkling level
will be reached after dispensing 0.5
litres of cold sparkling water
Warning CO₂ pressure can be
adjusted to a maximum of 4 bar
1
CO₂ plastic knob
2
CO₂ pressure gauge
CO₂ pressure can be adjusted using the
pressure reducer placed on the CO₂
bottle.
Pressure has to be regulated 0.5 bar
above inlet water value operating on the
CO₂ plastic knob.
For pressure increase rotate the knob
clockwise, for pressure decrease rotate it
counter-clockwise.

Advertisement

Table of Contents
loading

Table of Contents