Using Batteries; Inserting The Batteries; (Bottom Panel) - Roland DUO-CAPTURE EX Owner's Manual

Using Batteries

When using the DUO-CAPTURE EX with the [COMPUTER/TAB] switch (p. 10) set to "TAB, " three
alkaline batteries or commercially available rechargeable Ni-MH batteries (AA, LR6) are required.
Inserting the Batteries (Bottom Panel)
1.
Remove.the.battery.case.cover.on.the.bottom.panel.
of.the.DUO-CAPTURE.EX .
While pressing the tab, lift the cover.
2.
Insert.the.batteries.into.the.battery.case .
Make sure the "+" and "-" ends of the batteries are inserted in the
correct direction.
3.
Close.the.battery.case.cover .
When removing the batteries, first turn the DUO-CAPTURE EX
off, and then remove the battery case cover and remove the
batteries.
Note the following when using batteries
• Incorrect handling of batteries, rechargeable batteries, or a battery charger can cause leakage,
overheating, fire, or explosion. Before use, you must read and strictly observe all of the precautions
that accompany the batteries, rechargeable batteries, or battery charger.
• If used improperly, batteries may explode or leak and cause damage or injury. In the interest of
safety, please read and observe the following precautions.
• Carefully follow the installation instructions for batteries, and make sure you observe the correct
polarity.
• Avoid using new batteries together with used ones. In addition, avoid mixing different types of
batteries.
• Remove the batteries whenever the unit is to remain unused for an extended period of time.
• Never keep batteries together with metallic objects such as ballpoint pens, necklaces, hairpins,
etc.
• Used batteries must be disposed of in compliance with whatever regulations for their safe
disposal that may be observed in the region in which you live.
• When operating this unit using batteries, please use alkaline batteries or rechargeable Ni-MH
batteries.
• This unit will not operate using batteries or bus power unless the AC adaptor is disconnected.
• Even if batteries are installed, the unit will turn off if you connect or disconnect the power cord from
the AC outlet while the unit is turned on, or if you connect or disconnect the AC adaptor from the
unit. You must turn off the power before you connect or disconnect the power cord or AC adaptor.
• The power will turn off shortly after the Power indicator has started blinking. At this point, you need
to change the batteries.
• The DUO-CAPTURE EX cannot be used to charge rechargeable Ni-MH batteries. Use a commercially
available battery charger.
Introduction
Tab
11